Jump to content

2B Dash, Centre Console, Tunnel Top


theduck

Recommended Posts

I don't think the underside of this dash will comply with IVA regs -- the radius looks to be a lot smaller than the 19mm required. To be on the safe side a diameter of 38mm needs to be formed from the front flat face to the return edge at the back of the moulding.

Link to comment
Share on other sites

Don't wish to throw a spanner in any-ones build -- BUT -- Section 12 Interior Fittings Page 2 Note 7 "instrument panel lower edge --- radius of curvature not less 19mm or 5mm & be covered with a non rigid material"

 

You takes your chances -- Florin passed first time with a soft 38mm lower edge to the dash -- maybe things have changed -- ??

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...