Jump to content

S7 Floor


Guest gazza1591

Recommended Posts

Guest gazza1591

Does anyone with an s7 have any problems with the floor on the drivers side? Mine seems to bend when I'm in it them when I get back out it springs back? Passenger side doesn't do it. Just wondering if others have experienced this if so what have u done to rectify it?

Link to comment
Share on other sites

My S3a has the same floor, I ran 2 lengths of angle front to rear for both the passenger and drivers side picking up on the L to R forward crossmember and the rear tub lip behind the seats. The seat runners were bolted through the angle iron, this stiffens up the whole tub.

I also found that the rear floor stiffeners under the boot around the diff started to crack so I made a box section that bolted below and above the boot floor which stops the flexing.

Link to comment
Share on other sites

Mine was like snappers but my wife still didn't like it so I fitted treated 12mm exterior ply inside to give a more solid feel. Happy with that unless it gets wet inside then lift them out and dry them off.

Link to comment
Share on other sites

No but it's pretty obvious when you look under the car.

If you don't have the stainless angle gearbox support fitted simply run angle side to side at the front and back of the underfloor to join up the 4 front to rear supports

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...