Jump to content

V6 Type9 Fitting


tractor

Recommended Posts

just looking into fitting my v6 type 9 gearbox to my zetec turbo apparently the input shaft is 30mm longer than a standard type 9

feck thats one hell of a spacer i need

i have looked at spacer kit that retro ford do and apparently they say you trim the input shaft down 10mm but it dont specify how thick there spacer is !!!!!

Edited by tractor
Link to comment
Share on other sites

The ones I have seen are 20 to 25mm..... suggestion... Offer up without the bellhousing.... see how far it will engage... measure the distance.... allow say 5mm extra so you are not pushing against thrust...

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...