Jump to content


theduck

Member Since 09 Nov 2011
Offline Last Active Today, 10:17 PM
-----

#381053 Theducks Winter Mods - Youtube Series

Posted by theduck on Yesterday, 05:35 PM

The bodywork has been a bit neglected recently, time I sorted that out!




#380833 Theducks Winter Mods - Youtube Series

Posted by theduck on 16 February 2018 - 05:56 PM

Who knew lock wire was so sharp?!  Wont make that mistake again!




#380695 V6 Type9 Fitting

Posted by theduck on 13 February 2018 - 04:16 PM

If it works it isnt wrong  :rofl:




#380682 V6 Type9 Fitting

Posted by theduck on 13 February 2018 - 11:59 AM

Makita-GA4530KD-115mm-Slim-Angle-Grinder




#380608 Theducks Winter Mods - Youtube Series

Posted by theduck on 12 February 2018 - 09:02 AM

Can see them on burton, will make sure they are present and correct and if not Ill have to come up with a burton order. Sure I can find something else to top it up.


#380578 Theducks Winter Mods - Youtube Series

Posted by theduck on 11 February 2018 - 07:57 AM

A bit later than I had planned but part 14 Is here!




#380209 Theducks Winter Mods - Youtube Series

Posted by theduck on 29 January 2018 - 07:58 AM

‪ An episode full of excuses about why I havent made much progress‬




#380104 Nodiz / Megajolt 2.0 Pinto Map

Posted by theduck on 24 January 2018 - 11:55 PM

Using someone elses map isnt ideal, no two engines are ever quite the same. If you are going to the expense of purchasing a nodiz, spend the extra £100-150 on getting it on a dyno and setup properly. Otherwise you may as well have bought a new distributor from powerspark or similar in my opinion.


#380069 Points For Discussion At 2018 Agm

Posted by theduck on 23 January 2018 - 10:37 PM

Possibly. Though Ive just noticed its put it on the front page by being in here so would rather leave it here and helpmpublicise it to maximise member involvement.


#380045 Rhocar Constitution Changes Proposals - 2018 Agm

Posted by theduck on 23 January 2018 - 12:09 PM

If you would like to propose any changes to the clubs constitution to be discussed at the AGM please do so by completing the form in Boys in Hoods magazine and returning to the Club Secretary at the earliest opportunity before the AGM, or by emailing secretary@rhocar.org

 

If emailing please us subject line "RHOCaR Consitution Changes 2018"

and use the below template for the email

 

I propose the following changes to be made to the constitution/rules of RHOCaR. 
 
 
 
Proposers signature.............................................
I will / will not be able to attend the AGM.
 
 
Seconded by
Name...................................................................................................
Membership Number..................
Signature.............................................
I will / will not be able to attend the AGM.
 
If emailing please CC in the seconder to your proposal.
 
The current constituion can be found here http://www.rhocar.or...showtopic=40710



#379900 Tyres

Posted by theduck on 19 January 2018 - 09:49 PM

out of interest what have you gone for on the back?  I've decided I am gong to see how my PE2 cope, and if they dont, finish them off in a cloud of smoke before i upgrade.




#379869 Tyres

Posted by theduck on 18 January 2018 - 10:02 AM

Just double checked and they are e-marked so all good.


#379815 Collecting My Rh2B This Week...but..

Posted by theduck on 16 January 2018 - 07:40 PM

If it is an S7, unregistered it is worth very little.  There are also modifications required to bring them up to spec to pass an IVA, it can be done and its nothing difficult, but it needs doing and likely wont have been done if it wasnt presented for IVA.




#379791 Collecting My Rh2B This Week...but..

Posted by theduck on 16 January 2018 - 11:44 AM

As you aren't a member you cant read it, but there is a build thread on here from a member and it is one of the most meticulous builds I have ever seen.  I have seen the car in person and commented to him there is no way it will fail IVA.  It did, twice!  

 

If he was to sell that care honestly on ebay etc, I doubt he would even get £2k.  Keep that in mind.




#379766 Duratec Engines

Posted by theduck on 15 January 2018 - 06:18 PM

Probe lump is same as zach fitted isnt it?  You dont want one of them  :rofl: