Jump to content

Vr6 In A Fisher Fury


Snapperpaul

Recommended Posts

My neighbour has a VR6 lump on his drive, now I had one in a Ford Galaxy and it was impressive

It's only a 12 valve and I'm no idea if it will fit or what gearbox to consider but as I'm in thinking mode it's worth a think

Link to comment
Share on other sites

good strong engine... unless someone put box bolts in wrong.. then they crack water jacket.

2.8 175 ish bh. 2.9 corrado 190 bhp .

 

my mates is turbod at 430 bhp using a spacer to lower compression need chains doing around 100k.

 

but will run forever if looked after

Link to comment
Share on other sites

Pondering about the gearbox...

I think the VR6 was only fitted in a transverse configuration and probably did not have a separate bellhousing.

I was thinking of using a type 9 V6 box and adapting the VR6 bellhousing to fit the type 9 tat way I would only need to re-drill the gearbox to bellhousing bolt pattern or make an adaptor plate

  • Like 1
Link to comment
Share on other sites

I do a lot of in Head planning and not enough in garage doing

I need to get the Robin Hood running well enough to get to this summers events then start on the Fury.

The Robin Hood will have the old carbs put back on, the ignition refurbished with all new parts and then taken to a local rolling road, I will then not touch it in any inappropriate way until the Fury is up and running.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...