Jump to content

Theducks severely over running Winter Mods - Youtube Series


theduck

Recommended Posts

New video time!

 

This week, I reveal whats in the box, and whats inside whats in the box 😂 I also start work on the rear arches and start on a quick release hinged bonnet setup.

 

Edited by theduck
  • Like 1
Link to comment
Share on other sites

  • 2 weeks later...
  • 2 weeks later...

Have you checked the condition of the thin thrust washer on the clutch arm pivot pin in the bell housing? Mine was badly worn such that the arm had just started to cut into the housing, and also the anti rattle poly sleeve was cut through on mine. Got both from Burtons.

Link to comment
Share on other sites

The washer is very thin and easily missed, it's held in place by the pivot pin. You can knock the pin out via a hole in the rear of the bell housing. It's hardened and takes the clutch arm load onto the housing. I couldn't get the anti rattle sleeve as a separate item ( it looks like a piece of plastic tube) so I bought a replacement pin at the same time.

 

Rob

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...