Eddis

[jaimo]

just read that i can get ignition and run a zetec with just the eddis 4 without ecu it will be as a base map has anyone done this

just thinking its cheaper gets it running and megajolt when funds increase

 

[tractor]

I have driven my car with just the edis you wont break any land speed records but it is driveable

[jaimo]

What do you mean Chris is it as good as pinto with just eddis

And how much you wanting for carb and manifold

[tractor]

I seem to remember that at lower revs not much difference just when you are at higher revs cos no advance I will pm you about manifold and carbs

[richardm6994]

my understanding is that the EDIS-4 alone will set your ignition timing at 10-degrees BTDC throughout the rpm range......this is referred to as a 'engine-safe' mode.......the engine will run safely but have no power because the timing is fixed at 10degrees.

 

You need an ECU (megajolt for example).....which takes engine input signals (crank sensor and manifold load or TPS) and works out from an installed ignition 'map' what ignition timing is required at a given load/rpm and the megajolt tells the EDIS when to fire the coils...

 

Basically.....if the EDIS has no ECU controlling it then it fixes itself at 10-degrees 'safe-mode'.

[Fossett]

If you go with a Nodiz, you don't need an edis, you plug it directly into the coil pack.

 

very neat install really.

[speedtripledan]

Ive got a nodiz pro, dead easy to wire up can use pre existing megajolt maps aswell

No edis all new parts

Edited August 11, 2015 by DanE

[Bob Tucker]

Guys....Lew (windscreen man) is struggling with a Redtop that has bike carbs

and a NODIZ system fitted, & is not giving much power.

 

Is there any chance that your maps may get him at least up & running?

I know they are different engines, but both 2.0, both 16V.....it has to be close?

[biksz]

Jaimo if ya going zetec do it right first time don't cut corners with Eddis you say you got 2 grand to do conversion with so plenty of dosh to get it right

[speedtripledan]

Guys....Lew (windscreen man) is struggling with a Redtop that has bike carbs

and a NODIZ system fitted, & is not giving much power.

 

Is there any chance that your maps may get him at least up & running?

I know they are different engines, but both 2.0, both 16V.....it has to be close?

my nodiz was the same when i got it ran with no power what so ever. It was supplied with 1 d map ie no tps or temp correction etc. uploaded the correct 3d map and bam it goes like stink. Matt at mtec was a bit supprised when i told him how *bleep* his map was, if it was as claimed a dyno created map then i wont be using that dyno anytime soon

[speedtripledan]

Can email my zetec map if required, pm me an email ad

[Fossett]

I just got the Chester Sports Cars Zetec map from the Nodiz forums

 

Running a 3bar map sensor rather than TPS - pulls like a chuffing train