Prop Shaft Length

[Guest Andy Hamilton]

Finally got round to greasing the prop shaft on my standard 2B, type 9 gearbox to std diff. Rear grease nipple is accessible but obviously I put the floor over the front U/J and therefore grease nipple back in '06.....

Does anyone have a centre distance measurement between the grease nipples so I know where to attack the floor?

(There does appear to be a 'flap' in the floor that might be in the right place but I don't want to remove it until I have some idea of the measurement)

Looking forward to the advice.

[DAVE CASTLE]

Flange to centre of uj 625mm

[Guest Andy Hamilton]

Thanks Dave. I will attempt to make in incision at this point later!