Jump to content

Zetec Loom From Scratch


1186497

Recommended Posts

Hi all,

 

Just after a bit of advice, I am just about to start wiring up my zetec and trying to do on a budget so hoping to get a loom going without shelling out a fortune on one from off the shelf.

 

Blacktop running R1 carbs, fuel pump and megajolt. Anyone done this and if so how difficult is it?

 

I cant for the life of me find a website selling connectors for the temp sensor etc.. so is it best to get a zetec loom from ebay to get these bits?

 

As far as I can tell it is then just various wires through the megajolt and edis 4 to the various connectors and fuses and battery and then prey.

 

Thanks for any help

Simon

Link to comment
Share on other sites

A lot of them do look like Junior timer connectors and the ones for the injectors are. But the sensor plugs all have little registers and hollows in different places so you can't connect the engine temp sensor plug to the knock sensor socket, etc. Simplest to raid a scrapyard and get the cut off engine loom for a few quid so you can get all the right plugs.

 

Nigel

Link to comment
Share on other sites

Cheers all, didn't realise they had resistors built into the connectors so that scuppers my original plan. Off to a scrap yard tomorrow if I can find one as the good old days of them being everywhere seems to have been killed off by health and safety!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...