Jump to content

  2. → Viewing Profile: Topics: weaveym

weaveym

Member Since 05 Jul 2011
Offline Last Active 18 May 2013 06:50 PM
*----

Topics I've Started

Vacuum Gauge.

03 July 2012 - 06:39 PM

Evening all. Can anyone please tell me where to connect my vacuum gauge please. It is a 2.0 pinto with a twin choke weber carb. Cheers Steve.

Ignition Wiring.

08 June 2012 - 08:54 PM

Evening. I am planning on starting the wiring tomorrow on my Exmo. I was going to do it in stages. Starting with the ignition side first. Just wondering if any one can point me in the right direction with a diagram of sorts. I am using a none ford ignition switch.A start button. It is a 2.0 litre pinto with the ignition module with the 6 wires.A rev counter will be fitted.There is no wiring present at all. I have bought all the bits.ie Wire,spade connections,fuse box,relays ect. Any help would be much appreciated as electrics are not my strong point. Thanks in advance.Steve.

Viscose Fan

26 April 2012 - 07:00 PM

Evening all. Can anyone please tell me how to remove the viscose fan from my pinto  please. Im sure it must be a simple task,but ive no idea. Thanks in advance Steve.

Wheels Wanted

22 April 2012 - 01:04 PM

Hi.I am after a set of Minilite or similar wheels for my Exmo. 4x108pcd. 13" 14" or 15". 7" wide. Thanks for looking.Cheers Steve.

Body Work Progress

07 April 2012 - 08:04 PM

Evening all. Been busy in the garage getting the body work sorted on my Exmo. Reshaped the rear arches. Squared them off at the leading edge. And made the two end panels for the boot area. Shouldnt be long now before it goes foe paint.Cheers Steve.

  1. RHOCAR Community
  2. → Viewing Profile: Topics: weaveym

  1. Printfetti - Your photos on Confetti
  2. |
  3. E-Mail Remind - Reminders by email