Fitting Exhaust To Body

[Guest 2b_pablo]

got a new RH silencer and it has a little bar on it with 2 holes. There are 2 corresponding holes on the chassis. I tried to fit using a little rubber exhaust mount (with bolt each end) but it doesnt space the silencer out enough.

 

Is there a std RH part? Or something I can get from the local motorfactors?

 

thanks all

[miikae]

Hi , I have a piece of 2"x4" hollow section cut to the same width as the rubber stand off bobbin and that spaces it off ok ,

hope this helps .

 

Mike

[Guest peter2b2002]

don't fit the exhaust to the body sides the engine movement will cause the side pannel to crack, i used a piece of angle bent into a L shape fixed to the rear seat cross member under the floor ,then up the side to fix the bobins to

pete2b

[Longboarder]

Something along these lines, one bobbin to control vertical forces and one for lateral forces.

 

Nigel

[Guest salty_monk]

These are about as close as you'll get to what Nigel has drawn.... They were originally bolted through the side on 2 of those rubber mounts but sheared as the mounts weren't designed for weight in that plane.

 

FYI we tracked Drews one round Llandow with only a bottom mount, nothing on side panel at all & it held up fine.

 

Dan