Gaz Shocks

[keith kelly]

Just A quick One what size high tensile bolts should i use for GAZ coilovers?? i.e length and diameter.

[Guest phil howard]

Just A quick One what size high tensile bolts should i use for GAZ coilovers?? i.e length and diameter.

 

Give Richard a call a GBS 01623 860990

[fry61]

Measure the hole, with a vernier or go/no go with drill shanks, mine were 12.7mm so purchased 1/2" UNF to avoid possible slop with 12mm bolts; & use bolts not set-screws for best amount of bearing surface, HTH.

[keith kelly]

does anyone know where i can get some in nottingham (everywhere only has Metric )

Edited September 24, 2009 by unclechief

[miikae]

Try - Wright Engineering Company (Nottingham) Ltd.

Colwickwood works, Colwick Road,

Nottingham

NG2 4BG

 

Tel: 0115 9502284

Fax: 0115 9484967

E-mail: enquiries@wright-engineers.co.uk

 

Mike

[Guest Ian & Carole]

does anyone know where i can get some in nottingham (everywhere only has Metric )

 

 

If you give Dave @ dampertech a ring he will sell you some sleeve inserts to reduce your bush to 12mm, only pence each, think postage will be dearer than the sleeve.

If you bought them from him he would have supplied them FOC.

 

http://www.dampertech.co.uk/contact.html

 

HTHs

[keith kelly]

Try - Wright Engineering Company (Nottingham) Ltd.

Colwickwood works, Colwick Road,

Nottingham

NG2 4BG

 

Tel: 0115 9502284

Fax: 0115 9484967

E-mail: enquiries@wright-engineers.co.uk

 

Mike

 

Thanks Mike, very good contact sorted me out with the bolts and nuts for a couple of quid and dropped them off at work while passing

 

 

thanks to all for their help.

 

 

regards

 

keith