Sierra Wiring Diagram / Haynes Manual

[Guest HS88]

Hi,

 

Does anybody have a Haynes manual with the wiring diagrams for the Sierra?

 

Or have any already scanned in/photocopies?

 

Mainly looking for the steering column/ignition switch diagrams....

 

Would be very grateful if anyone can scan in the diagrams to assist with the wiring loom of my build.

 

Thanks!

[Guest MarkB]

http://nw.rhocar.org/vickygreenswitchwiring.htm

 

http://nw.rhocar.org/build%20tips1.htm

[knights_templar]

which loom do you have?

 

if its a race do you need a full loom, there is a race/track day only loom?

[richyb66]

http://www.rhocar.org/index.php?showtopic=27340&&do=findComment&comment=208587

[Guest HS88]

Thanks all.

 

I have a sierra steering column which has the wiring still attached. Not actually sure which loom these are from as it was purchased off eBay.

 

At worst, I can probably work out the wires by taking the stalk apart and tracing the wires to the components...

 

I plan to make my own loom up to use these wires in my build.

 

Cheers,

[Guest robinj66]

Look for markings on you the stalks - they will either start with 83, 87 or 90. 83 is the earlier pin configuration and 87/90 is the (same) later pin configuration.

 

Purely from memory, the 83 stalks had the horn as a stalk function (it was on the steering wheel centre for the later stalks).

[Guest HS88]

Thanks I'll take a look when I can next.

[Longboarder]

I have this to offer. Think its for 87/89/90 switches.

Should add the colours are ford sierra loom colours so will match the tails on the plugs but probably not your aftermarket loom

 

Nigel

[Guest HS88]

That's excellent. Thanks