Jump to content

Rear Number Plate Holder


johnhetherington

Recommended Posts

After a bit of advice please on the rear number plate holder I have made.

See picture attached, I will be fitting a rubber edge on the outside edge but my concern is that the plate will protrude and stick out and may fail the IVA

Any thoughts or comments greatly received.

Thanks

John

 

 

www.johnkitcar.com

post-2376-0-43563800-1395784546_thumb.jpg

Link to comment
Share on other sites

Why not fit it higher up on the spare wheel? The spare may need a cover as edges of the alloy wheel may not comply with radius rules of IVA ( ain't life grand??) The same wheels on the road though are O.K. IMO

Link to comment
Share on other sites

Just a cloth cover over the spare will solve edge issue

Rear plate should be vertical, as rear panel is not the more picky tester will fail on that

The spare wheel carrier as it is rounded should pass without spare wheel

Link to comment
Share on other sites

Guest Chris Russ

.....Just to add my two-peneth, - my set-up on my Exmo was the same as yours, all I did was to buy a cheap spare-wheel cover off of e-bay & that took care of the tyre radius, - as for the number plate bracket, mine was in the same place as yours, BUT cut it about 10mm shorter than the number plate ( so the number plate is longer )....The tester cant fail it as you're not supposed to mess around with number plates!! --- Mine passed IVA last year!

 

Good - Luck!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...