Ford Focus Rear Suspension Bush Remover

[Grim]

Has anyone got a ford focus rear suspension bush remover i could borrow/buy, as per the link below. Seems like a lot to spend on a single use tool, so thought I'd check here first.

 

 

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F253712686998

 

Andy

[fry61]

I've got a whole host of mechanical/hydraulic presses Andy, but you are rather a long ways up country -- will be in Royal Leamington Spa week-end after next at Model Engineering Expo if any help.

[Grim]

I've got access to a press, but that would require removing the whole arm, hub, brakes etc, which is a much longer job.

A two leg puller could also be used if i had a bespoke plate, which is what this tool does, but would take time to make

Edited October 11, 2018 by Grim

[fry61]

My hydraulic press is portable --- Sykes Pickavant 15000 series -- But may need to turn a tube to right diameter for the pushing side.

 

E-bay 123287146326 is a picture of the kit I have plus loads more arms & ram extensions.

The base plate is two parts so can be adjusted to suit hole size required, side arms can be up to 12" long.

Edited October 11, 2018 by florin metal works