Jump to content

Replacing exhaust


deano266

Recommended Posts

Hi guys.

I have a question about fitting the exhaust. the pipework from the collector has an outer diameter of 2 inches and the exhausts i'm looking at getting have an outer diameter of either 2 inch or 2.5 inch.

The differences between the exhausts are a bigger can size.

My question is does it matter that the exhaust inlet gets bigger or will this cause issues

Link to comment
Share on other sites

Hi Deano, I've just fitted one of the large cans from GBS to my 2B with the pinto manifold (modified to fit the Duratec) and as you say has an external size of 50.8mm (2") the internal size of the GBS silencer is the correct size to go over this, but I found this would leave my exhaust shorter than I wanted. The answer I found was to buy a exhaust repair section from ebay in stainless that is 50.8mm expanded at one end, this then fits over the collector outlet, and cut to length fits inside the new silencer. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...