Mazda master cylinder

[Mrbarry]

Went to get the zero out today and the clutch peddle was on the floor. Well it had around 20mm of travel. There was no fluid in the reservoir so I topped up. It simply poured out of the front seal. I was going to rebuild it but I can get a full new master and slave cylinder from MX heaven for £40. No brainer. I assume it is a standard MX5 cylinder they use on a Mazda zero kit build?? If not no point ordering that lol

[Mrbarry]

Just to close this thread, I did order from mx5heaven and it works a charm, be aware however if you go the same route the fluid reservoir is longer than standard so you need to swap them over, the rear ended fastens to the master cylinder body differently so you have to faff a little, but nothing major.