Wheel stud removal

[Mrbarry]

I asked a while ago about this, pounding them out with a hammer seems a bad idea, shock loading the bearings metal on metal in a direction they aren’t designed for seems questionable at best.  So I decided to make a removal tool. It works like a charm and presses them out like they are made from butter. Then again it would the hydraulic pusher is a 12 tonne ram. 

If anyone needs ideas here are pictures. Took 20 minutes to make from 2 flanges and a male coupler. 

https://www.dropbox.com/s/0dcg1ep8o9bakqq/Photo 13-06-2019%2C 15 57 46.jpg?raw=1[/IMG]

https://www.dropbox.com/s/5cfc7lna7cx2za4/Photo 13-06-2019%2C 15 57 57.jpg?raw=1[/IMG]

https://www.dropbox.com/s/qjkk39t3dothpbk/Photo 13-06-2019%2C 16 02 56.jpg?raw=1[/IMG]

Edited June 15, 2019 by Mrbarry

[Mrbarry]

codes don’t work on this forum it seems. Fine on any other forum I use. Links are live anyway.