Jump to content

Pinto - Oil Port locations


Guest SFX-Joe

Recommended Posts

Guest SFX-Joe

Hi all,

 

Fitting a Accusump tomorrow. I want to ideally plumb it in to its own oil port on the block. However The only one I can find is where the oil pressure sensor goes in? Is there another one lurking around anywhere that anyone knows of?

Thanks!!

Link to comment
Share on other sites

Not likely. I used a T-piece to drive an oil gauge and a pressure switch.   You just have to make sure the connectors are correct size.  The Rover engine uses M10, not sure about the Pinto.  (Just search Amazon for 'oil pressure t'

 

image.png.6f97180c6fe8a1d2d014a8049c102976.png

Link to comment
Share on other sites

Guest SFX-Joe
Just now, alanrichey said:

Not likely. I used a T-piece to drive an oil gauge and a pressure switch.   You just have to make sure the connectors are correct size.  The Rover engine uses M10, not sure about the Pinto.  (Just search Amazon for 'oil pressure t'

 

image.png.6f97180c6fe8a1d2d014a8049c102976.png

I have one of these already as I am running a mechanical gauge and a digital one. I can remove one, no problem but ideally would like the Accusump ported elsewhere. Never mind!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...