Jump to content
Daled

Engine work - completed

Recommended Posts

Hi, as it's the beginning of the "off season" I decided to get some done to work done to my old pinto engine so I can focus on some of the other stuff. The cam bearing was quite noisy and the engine was feeling very tired... so I fitted the following:

Kent gts1 cam kit

Dual Weber 45 DCOE (yes I know it should have been bike carbs) 

New water hoses

Skimmed the head and case. 

New gaskets etc.  

Accuspark ignition 

Electronic fuel pump 

 

The result so far is much better idle and it revs very well. I am going to run it in over the next couple of months and then have it dynoed but I thought I would try and start a thread show casing what work everyone gets up to while it's a little colder

 

cb0509ef-0b25-452f-8228-f724696991ba.jpg

20191108_154557~2-962x1051.jpg

  • Like 1

Share this post


Link to post
Share on other sites

That looks very smart, some nice details there. 👍

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...