Duratec engine programming

[Handyandy]

Hello all

My first post so please forgive me if this has been discussed before,

I'm looking for some help with my new build,I've just finished a year long restoration of my s7, it passed it's mot for the first time in over 10 years. I'm running a duratec on standard injectors and a microsquirt ecu, but I'm struggling to find a standard ignition timing map, is anyone on here running a duratec, I'm keen to see an advance table for a standard set up. I'm experiencing some hesitation when cruising and I'd like to eliminate ignition advance as  being the issue.

 

Any help would be greatly appreciated. Cheers Andy

 

[tractor]

i have one you can compare but i cant post it here you would have to go to our facebook page  i have uploaded a map 

Edited April 11, 2021 by tractor

[Handyandy]

Great thanks tractor what's the Facebook page I need to head over to?

[richyb66]

https://www.facebook.com/groups/514980222217443/permalink/1311793645869426/

[theduck]

I'd probably skip that 90.0 cell though 

Edited April 13, 2021 by theduck

[blue]

Agree that map needs a little tweak.   Some of the numbers are lower then the corresponding numbers.   11 /15 /14 /17.   But dam good as a base to tweak to get someone started. 

[Handyandy]

Thanks guys much appreciated,  that has made a nice difference I just need to fine tune but it's much better cheers.

[tractor]

yes it was a map in progress but gives handyman a direction to go in  

Edited April 15, 2021 by tractor

[tractor]

i have just posted another map with a slight ignition retard i was just being conservative whilst tuning with the turbo

[Handyandy]

Thanks again tractor, the car is running much better every time i adjust the maps, and essentially i just want it to run ok until i finish all the shakedown work then ill try and find a local dyno tuning shop and get them to set it right.