Side Panels

[Guest grahamdale5]

There are lots of articles around about fitting the sude panels, but I still have a question. How do the panels fit with the support angle underneath. Could a few of you post some pictures for me?

[Guest jetskijase]

HI mate

You need to take the angle off then fit the panel and drill the side panel and refit the angle, just tighten up slowly and keep an eye on the side panel and it pulls the panel tight.

 

Thats what i did and it went fine.

 

Jase

[Derek]

I did the same as jetskijace, have attached a photo perhaps make it a bit clearer.

 

Just be very careful as you pull the side panel around. Where the bonnet ends at the cockpit is where I have made a mess!!! :boohoo:

[Derek]

Sorry not very clear at all. Perhaps I should pay for the resizer!!!

[Guest grahamdale5]

You could try a free resizer

http://www.microsoft.com/windowsxp/downloa...ppowertoys.mspx

 

 

 

Thanks for the help so far. Any more Photos?

[Derek]

Have not had time to sort the link yet, so here's another 2 complete with watermark!

[Derek]

The other

[mellors55]

Derek

I'm sure I recognise that good looking bloke in the red coat!!!

 

John

[Guest daveg]

I'm sure I recognise that good looking bloke in the red coat

yep so do I......I saw a picture of him on crimewatch

[Guest grahamdale5]

Thanks Derek, I can see how you have done it. Maybe I'll have a go next weekend.