Jump to content

nightracer35

Community user
  • Content Count

    182
  • Joined

  • Last visited

Community Reputation

0 Neutral

1 Follower

About nightracer35

  • Rank
    Wheely good builder!
  • Birthday 06/24/1967

Previous Fields

  • Car type
    series three a with a 2.0 pinto(could not get twin cam to fit)
  • Full name
    ron hadaway

Contact Methods

  • Website URL
    http://

Profile Information

  • Gender
    Male
  • Location
    rotherham s61 4nj
  • Interests
    cars, banger racing, fishing, camping, airshows and aircraft and a new challenge!!
  1. hiya andy, does your friend still have the sierra? i am after the front uprights and calipers and also the complete steering shaft from rack to steering wheel(nad steering wheel also, many thanks. ron.
  2. couuld i have 2 seta please i doble postage. thanks. ron.
  3. has got ideas of building another kit car

  4. hiya do you still have the sierra?? im after front uprights and steering column and a few other bits and pieces, thanks. ron
  5. thanks chris will buy a new 1. ron
  6. thanks for your replies. ron
  7. hiya which plugs you after?? imay hav 1 or 2 knocking about
  8. thanks for all your help, i am a happy bunny, now i can flash and see in dark lmao, its easy when you got good friendson here who know what there doin lol thanks again. ron
  9. thanks for all your help, i am a happy bunny, now i can flash and see in dark lmao, its easy when you got good friendson here who know what there doin lol thanks again. ron
  10. hiya,its not too expensive for a new cylinder, i just bought a new 1 as nine also leaked,ron
  11. hiya, i need to replace my clutch quadrant for a new 1 (red) but as im using an 1800 gearbox (h reg)on a 20ltr pinto not sure what size cable should it be ?? are the 1800/20 ltr clutch cables the same length for each coloured quadrant, many thanks .ron ps, what length should the cable be??
  12. hiya, can any please tell me how much i should cut my sierra wipers down for a series 3a?? nand how hav they been fastened under the dash.many thanks. ron
  13. nightracer35

    Overheating

    have you tried flushing the engine?? try it with no thermostat in?? have you replaced head gasket?? if so have you checked the water holes in gasket to block line up ok?? . hope these may help. ron
  14. i am using the vicky green wiring loom, stalks are off a j reg sierra, i had the lights working before i had to take steering column out to replace the steering bush, now nothing,if i push the light stalk down the side lights go out, so i undid all the connectios from stalks too vicky green loom andreconnected them, now cannot find on the diagram where the blk/brwn wire goes to?? wish i had never took the column out now on the stalk there are 2 blk/brwn wires 1goes to the stalk on left (wipers i think) the other is ????? thanks. ron
×
×
  • Create New...