Vaughan

Hi i am looking for a pair of harnesses for my s7. i have a pair of Luke fitted but they are blue and really spoil the look so wanting black or red 4 point please. I am also on the look out for bucket seats, extra narrow as it’s a monocoque if any one is having a clear out? Many thanks

She started up tonight, what a feeling

Hi i am about to tackle the fuel system and I am hoping for your advice. I have a tank with 4 threaded bolts at one end, and a flow/return at the carb. (Sierra DOHC) at the other . do I get the original sierra submersed pump/sender or are there any other options? Bearing in mind the Sierra pump has a ring fitting and I am not sure how to convert it into the tank. also, what is the best and safest fuel line and route to take from back to front please (s7 monocoque) thanks Vaughan

Hi all may I ask what is the best motor etc to put in an S7 tyi Vaughan

Thanks Brumster, you da man! is the nut on the end of the braided hose ok for Iva? Thanks Vaughan

Is this ok gents?

Thanks Richy, will there be an issue if I connect the rubber hose directly to the callipers (heat?) as im trying to do away with the short copper pipe on type 16 callipers. Thanks

Thanks Richy, will there be an issue if I connect the rubber hose directly to the callipers (heat?) as im trying to do away with the short copper pipe on type 16 callipers. Thanks

Hi do I have to fit braided front brake hoses for Iva? Thanks

Hi i am looking for 8” rear brake assembly to fit Cortina axle please. I have drums and back plates but no furniture at all. I bought some used Sierra 9” assemblies but they don’t fit on the axle end if they are of any use to anyone? Thanks Vaughan.

Sorry for the late response Are the seatbelts up for grabs? or do you have any?

Thanks, it has never seen fuel so now is the time to re design me thinks.

Can I weld brackets to the top of the fuel tank to bolt to the floor rather than having tank straps? IVA friendly of course! Thanks

Where are you based please

Hi does anyone have any seats/seatbelt combinations available to fit into a monocoque suitable for IVA? Thanks

Thanks Paul

Thanks Paul for your response where did you get it? What are the sizes if you don’t mind many thanks

I am fitting a Sierra DOHC into a monocoque. The engine inevitability sits high. Does anyone have any info or recommendations on sourcing a scoop and it’s iva implications? i need about 700mm at the front, 400 wide 850 long. TIA. Vaughan

I ain’t scared!! getting there!!

Four branch for the above wanted please.

Thank you, you have saved me hours of frustration