Stewart

When glazing with ribbon rubber the rubber should be stretched thus making it thinner and the end fit tighter.

you may of heard them before but replays,this must be a recording.

Thanks mark but mine are cobra hoops and was hoping to fit on to the apex of the bend

Thanks Simon

The resistors came allready attached to the LEDs

I have ten red LEDs 9000mcd wavelenght 620-630nm Mcd 7000---9000 Vf(V) 2.0--max 12v if I install these attached to the existing brake lights as they have resistors do I need extra fuses or anything else

Have you any photo`s and can you give part number and were obtained etc

Have you any photo`s of it fitted??

Has anyone solved the problem of fitting high level brake lights to cobra hoop roll bars???

Sump breather my 2ltr pinto currently has a cone shaped filter on it, is it better to run the breather up to the oil filler neck or leave as it is???

There is a first time for every thing

Have found a man that sorts pinto engines for a living mainly race engines but he is most helpful and sorted it in minutes

Yes I thought what a good day for the first long drive ,take it to be tuned and then the open road,WRONG on way to tuning water pump failed limp home and wait till Wednesday for a replacement

No not yet but have been recomended to a guy who lives fairly close who prepares pinto race engines,he has told me to take it to him (when its dry) and he will tune it so here`s hoping,watch this space!

Try simon at www.simonbbc.com at powerspark ignition he is very good and very helpful if you phone him he stocks every type of ignition system.

It looks a bargain at that price its less than half the price of the kit with engine hubs etc included.

Thanks to CMA RHOCAR for info on how to resize photo`s

Mine looks like this item on ebay 251276153742

Took pictures but its says wont upload file to large,how do I make them smaller???

The idle adjustment screw item 58 is blanked off on mine

How do I adjust the fuel air mixture when there is not an ajustment screw as on my previous carb

Went on the 18th engine and vin number duely inspectednow 21st still not heard anything

Its Chasewater show this Sunday

Jason, have you spoken to Simon at GBS he was a godsend when I did my wiring I even had him on the end of the phone in the garage while I connected some of his suggestion, unfortunately due to a computer crash I lost most of my information but still have some paper work if it may help if you want to pop up I can show you what I have.