Sceen Position

[TonySuperSpec]

Hi all

 

Trying to determine where to fit the screen on a Superspec!

 

I do have a copy of both the 2B and Superspec videos.

 

No mention as far as I can find on the Superspec set of the position of the screen related to the demister holes where as on the 2B Richard talks about half an inch in front.

 

What have you guys who have fitted the screen done .. Half an inch seems a long way from wiper spindles based on the spacing between spindles and demister vents to me.

 

Any help greatly accepted

 

Really getting on now again still having problems with the knee when I need to get into tight corners but have had the seats in and getting in and out of the car no problem now where as six months ago could not bend the knee enough so failed, this improvement is spurring me on to get it finished.

 

 

Cheers

[andyparry]

I positioned the screen on mine in accordance with the 2B videos, only to end up moving it when I fitted the sidescreens and hood. My advice would be don't fit the screen in isolation from the wet weather gear (assuming you have it); do both at the same time..... The position of the wet weather gear and angle of the windscreen will pretty much determine where the screen will end up. Mine ended up with the screen over the demist holes! I do have good head clearance for the weather gear though......

 

HTH

 

Andy

[Guest gdc]

ni

i think i am in the andy school of thought.

fitted the 2b screen as the vids ony to have to remove the demist vents later move the screen back almost over the vents to fit the wet weather gear.

sva withought screen and then fit all weather gear as a package.

regards graham

[Guest Dredd]

On my SuperSpec, the front (leading edge) of the support bracket is 5" away from the front edge (engine bay) of the scuttle

[Guest rusty]

on my superspec the top of the screen is 1020mm from the roll and 215mm from the btm front edge of the screen too the front edge of the scuttle, good luck