2b Measurement Of Bottom Hoop

[Guest Getting There]

Hi

 

Since the accident in September I have been fighting with the gas board through the solicitors. They are arguing with the height of the lower sump hoop (the one that picks up from the engine mounts and goes under the engine front pulley). The hoop on mine is badly damaged so they cant measure the height of the road surface. Can a few people measure me the height from the bottom of the hoop to the floor, and also the bottom of the wishbone front lower square section mount to the floor to take up any differences in ride height.

 

Many Thanks

 

Chris

[Guest peter2b2002]

just checked my 2b , bottom of the plough to floor 75mm, lower wishbone square section to floor 185mm, this was done in my garage so it was level and with no one on board.

good luck.

peter2b

[Guest chris brown]

Mine is about 3" (sorry 75mm in new money) also

[Guest manglemender]

I have the ride height a bit lower so mine measued 60mm to the Plough and 170 to the bottom of the lower wish bone mount box section.

 

Nick

[Adrian]

i have 75mm and 170mm