Engine Mounts

[Guest Ginzie]

I have an 87 2.0 pinto lump about to be dropped into my chassis. I appear to have thrown the engine mounts but would not be too happy on using the old ones after an engine rebuild and twin 40's. i still have the alloy pieces, no rubber. goes anyone sell them? ebay show several but Cosworth,I assume the will not fit. I would rather have new ones, Ford not helping much. any ideas?

[Guest robinj66]

Are these any good? [NTDWM]

 

Or can you use this type these ? [stiffer than the Ford equivalent]

[Guest Feek]

Car Builder Solutions have some "universal" engine mounts. Spotted them t'other day while looking for summat else. Might be worth a look.

 

Look towards the bottom of this page:

http://www.cbsonline.co.uk/category/Mechanical/Rubber_Mounts,b.html

 

 

Cheers,

Feek.

[Guest Ginzie]

Thanks robinj66, I did see the ones on ebay but wondered about their condition as being used, like the idea of the Land Rover rubber and have heard of these being used before.

 

Feek, have added the website to my favorites as I am bound to go shopping there at some point.

 

Ginzie