Vicki Green Loom Problem

[Guest mc_clean_david]

I have a set of sierra clocks with the rev counter on the left, speedo on the right, fuel gauge on the left and water temp on the right. There are battery, indicators etc underneath. The loom plug sits into the rear of the clocks in a horizontal position and has only 12 pins - most diagrams seem to have 13. I am using the vicki green loom. I've tried the vicki green wiring diagram to no avail. Could anyone help??

I need the wiring order left to right when looking at the plug attached into the clocks.

 

David Mc Clean

[Guest TerryBarry]

Well this is how my instrument panel was connected ('89 2.0l GL)

Pin # Wire Connection

Colour Panel Harness

1 Blue / White Main Beam

2 Black / Yellow +12v from IGN switch

3 Brown / Green Oil Pressure

4 Black / White Indicators

5 Green Tachometer Coil (Green)

6 Brown / White Temp Gauge

7 Brown / Black Fuel Gauge

8 Black / Green Indicators

9 Brown / Yellow Brake Warning

10 Blue Alternator Warning

11 Brown Earth

12 Green / Slate Illumination

 

These are viewed 1 to 12 (Right to Left) Viewed from rear of Panel

 

I hope this is clear - it has lost something in transfer between programmes

e-mail me and I can send you an Excel file

[Guest paul2]

:boohoo: i have not got to panel yet, i hope its not as bad as wipers/lights none of wires match up just spent 3hrs trying to get it right now time to hit vodka.

[Guest klaxon]

Hi david

I have the same instrument unit as terry and I agree with his listing but the one from my 1986 2.0GL was different. The speedo only went up to 130 mph and the wiring was 12 pin but in a different order.

 

1. brown/white Instr. lights

2. green Tacho

3. brown/black Fuel gauge

4. blue/white Main beam

5. black/yellow Feed from ign.

6. brown/green Oil pressure

7. black/white Indicator lamp

8. black/green Indicator lamp

9. blue Ign. light

10. brown yellow Brake light

11. brown Earth

12. brown/white Temp gauge