Jump to content

Servo Exhaust Clearance

Guest Alan Harrison

By Guest Alan Harrison
in Mechanics

 Share

Recommended Posts

Guest timswait

Guest timswait

Posted
Posted

When I retro fitted a RHE 4into1 exhaust I found I had negative clearance between the exhaust and the servo! After much fiddling I managed to get about 20mm, I've fitted a stainless heat shield, and (touch wood!) haven't had any problems. The master cylinder is heat critical, though (you don't want boiling brake fluid) and I did require a heat shield there to pass SVA. Since fitting the new exhaust I've additionally wrapped the master cylinder and the brake lines in loft insulation and baking foil, looks daft but I think it's quite effective! It's also stayed on suprisingly well (touch wood again!)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
 Share
Go to topic listing

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...