Carb Bits

[Guest Christine]

Hi, when I brought my S7 earlier this year it came with a DGAS carb in a carrier bag, I was told it needed a service. Looking at it the choke butterflys are missing, has abody got any spares for sale ?

 

I could also do with a photo/photos of what it should look like to see any other bits are missing, cheers

[Guest MrT]

hi Gary

 

you dont need the choke butterflys unless you specifically want he choke, it should start/run without just pump throttle about 3 times

 

I do have a DGAS for sale if you get no were, its only done a couple of thousand miles from new

 

regards

 

Paul

[Guest Christine]

hi Gary

 

you dont need the choke butterflys unless you specifically want he choke, it should start/run without just pump throttle about 3 times

 

I do have a DGAS for sale if you get no were, its only done a couple of thousand miles from new

 

regards

 

Paul

 

Hi paul, any chance you could post a couple of photo's of the carb, I'm not sure it anything else is missing, there seems to be a threaded hole on the top left of float chamber.

Cheers.

Garry

[Guest MrT]

hi

 

yes can do but I am in Belgium working so tomorrow or Friday.

 

regards

 

Paul

[Guest Christine]

hi

 

yes can do but I am in Belgium working so tomorrow or Friday.

 

regards

 

Paul

 

Thanks Paul it would be a great help.

Garry

[Guest Noddy006]

Hi Garry

In case you can't get any missing bits cheap from somewhere - I managed to get a complete second Hand DGAV carb (Believe same as DGAS except water temp choke) for £30.00 from Escort-Tec Phone Mark 07855 985220. Would probably post to you. My DGAV seems to be working fine. (Only done about 200 miles though). Also have you looked in the Sierra Haynes manual for drawings of carbs or possibly try the Weber web site. Hope this helps. Ian H

[Guest robinj66]

here's a schematice for the carb DGAS Diagram a

 

and the stripdown /setup Manual

 

Once you'va had a chance to work out what's missing, post up what you need. I'm sure this club can get you started.

[Guest Christine]

Hi Garry

In case you can't get any missing bits cheap from somewhere - I managed to get a complete second Hand DGAV carb (Believe same as DGAS except water temp choke) for £30.00 from Escort-Tec Phone Mark 07855 985220. Would probably post to you. My DGAV seems to be working fine. (Only done about 200 miles though). Also have you looked in the Sierra Haynes manual for drawings of carbs or possibly try the Weber web site. Hope this helps. Ian H

 

Thanks Ian will give him a bell if this one to expensive to fix.

Garry

[Guest Christine]

here's a schematice for the carb DGAS Diagram a

 

and the stripdown /setup Manual

 

Once you'va had a chance to work out what's missing, post up what you need. I'm sure this club can get you started.

 

Cheers Robin, just the job, even got a this of part numbers perfick!

Garry

[Guest whiz]

Hi ive got a set of butterflys & all the choke stuff sitting as ive just removed them from my carb as I don't run with a choke , removing them allows more air through the carb. your more than welcome to them as i have a complete spare carb also.

Andy

[Guest Christine]

hi Gary

 

you dont need the choke butterflys unless you specifically want he choke, it should start/run without just pump throttle about 3 times

 

I do have a DGAS for sale if you get no were, its only done a couple of thousand miles from new

 

regards

 

Paul

 

P.M sent Paul.

Garry

[Guest MrT]

Send me your PM, I have photos for you

 

Paul