Longer Wheel Studs Needed

[Guest The Modfather]

As the title really. The wheels that I have fitted have quite thick hubs, and there's not much stud sticking through. It is sufficient, but I would like a little more just in case. Problem is, I'm not sure which ones are the right ones, as there are loads on Ebay.

Can someone advise please?

 

Regards

 

Darren

[Guest MarkB]

transit studs normally do the job just right

[paul_r]

There the ones I used and they seem fine.

[Guest The Modfather]

Thanks guys, i've ordered the correct fitment but in 63mm, hopefully i'll get them in the next day or two.

 

Thanks again, Darren

[keith kelly]

hi daz,

how did you get on with the new studs, i have the same problem especially as i need bigger spacers

 

 

reggards

 

keith

[Guest The Modfather]

I'm still waiting on them due to the snow etc. I'll let you know how it goes, but removing them is fairly easy, just hope they're the right ones, been told that they are

[Guest Ian & Carole]

I hope that you have the right ones, there are two sizes of shank, the bit that fits in the hub, my first set were the bigger ones

[keith kelly]

any success yet daz???

[Guest The Modfather]

Hopefully doing them this weekend, or earlier if possible. Will post my result.

Darren

[Guest fathead]

Hopefully doing them this weekend, or earlier if possible. Will post my result.

Darren

 

Hi Darren

 

Hope you are well. Did you have any joy with the new wheel studs? I put the alloys on today and the front ones are rubbing on the sliding pillar so think I will need longer studs and spacers too. I managed to strip out the electrics and take the rest of the panels off today and it is now on axle stands ready for the suspension to come off so I can paint the chassis.

 

I'll let you know how it goes.

 

All the best

 

Steve

[keith kelly]

i had fun changing mine the studs were in solid, got them out eventually but got carried away and striped the suspention while i was there. good job realy as there are a few bit that need replacing and could have caused problems!