Jerbear

Haha, people often do that. john Lamsley did it originally and I’ve spoken to him today, it’s just a 3hr drive/trailer journey that’s putting me off

Hi all, looking for a good tuner with Dyno for my GBS Zero with Zetec. Using AT Power throttle bodies and Emerald ECU Based in Herefordshire. Any recommendations.,willing to travel a bit for good job. many thanks Jeremy

Currently checking wiring, have put a busbar for earths under dash. Wiring is/ was a bit of a bodge in places, mainly the wide band lambda , but gauge reads ok .?

Checked voltage, that seems ok. Agree that related to recent work. Will look into the data logger . Have had a PC on it before.

Hi all, First post on here. Aquired a 2019 Zero with 2.0 Zetec.. car hardly used since IVA. less than 1k. drove car home, 5hr journey, All good.Used car for a few runs before weather turned. One of my gripes was poor gauges. Couldn’t see or read oil, water or amp gauge so swapped for Little Devil gauges and added oil temp. Since this had engine misfire/popping and reluctant to pick up. Running K6 emerald ECU with wide and lambda. Have swapped obvious, plug leads etc but no better. Checked wiring but can’t see anything obvious. Did disconnect ECU wiring to tidy up. any help appreciated Jeremy