Attaching Twin 40s Double Cable To The Throttle Pedal

[Guest tom2b]

How do i attach two throttle cables from my twin carbs to the throttle pedal?

[Big Jim]

Like this (see photo) the square block has grub screws to clamp the cables, and is available from Weber agents. you will need to modify the end of your pedal and weld a piece of bar to it instead of the present end.

 

Don't forget to make a proper adjustable pedal stop to control the amount of pedal movement at full throttle, or you'll bend the shafts in your carbs.

 

Unless someone has the part number, you'll have to explain just which part you require, try Webcon tel No; 01932 787100 or e-mail sales@webcon.co.uk

[Guest tom2b]

Thanks for that Jim, most helpful. Glad you mentioned adding a stop else i probably would have bent the shafts!

[Big Jim]

Thanks for that Jim, most helpful. Glad you mentioned adding a stop else i probably would have bent the shafts!

 

Yes, it's a common problem. make sure that the pedal itself hits a stop just before the carbs gets absolute full opening.

[Guest tom2b]

ouch, burton power want £13 for that!!!!

[Guest Ian & Carole]

Come on Tom

 

your'e a Hoodie

 

you could make one.

 

All you need is a bit of block steel and a drill, you could always use a 1"" length of 3mm angle iron with the holes drilled through and either bolt or weld it to the top of the pedal.

 

HTH

 

Ian J

[Shandylegs]

Tom

 

I think I have a couple floating round in the back of my garage. Let me know if it's any use I'll have a look when i get home from work.

 

Thanks

Duncan

Edited October 24, 2006 by Shandylegs

[Guest tom2b]

Duncan if you have a spare one that would be great, failing that i will make one!

Regards

Tom

[Shandylegs]

Tom

 

I do have one that is spare. P.M. me your address details and I'll forward it on.

 

Thanks

Duncan

Edited October 24, 2006 by Shandylegs