Jump to content

Recommended Posts

Guest TonyH
Posted

Hi,

I have a part built (2 previous owners) 2B "sliding pillar" (converted by me with GBS wishbone kit); my question is that the previous owner has put a plastic tube through the tunnel (attached with cable ties) and put the brake pipe and loom through it. Should these be separated and clipped with "p clips" or is this the standard way?

Also I don't have any pictures of the build so far, will the "SVA Test" require any, and if so what?

 

Thanks

TonyH

Posted

Loom through a conduit is fine, but i would P clip the brake and fuel lines seperatly, though you can clip the loom to the brake lines, but not to the fuel pipes,I would clip the tube with p clips rather than cable ties though

 

 

Hope that makes sense

 

Mitch

Guest craig030774
Posted

hi tony take as many photos as you can especially areas that will be covered i.e tunnel inside seat belt mountings, it is nice to look back on old photos when doing the build if you get to the point of " it does not look like anything is happening " you can look back and see where all that time has gone

p.s fill in your location bound to be someone close

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...