Tonou Cover

[Guest rizla]

on my s7 it has a open boot ie no lid........heres my idea ,i have a tonou cover that i can no longer use due to fitting high back seats,if i cut my coverat a point just behind the driver and then fit the rear section to the car would this make a reasonable boot covering

your thoughts would be gratefully recived

[Big Jim]

Yep! do it!

 

[Guest rizla]

thanx jim your opinion is greatly valued ta

[Guest piddy]

Sounds good to me

Piddy

[Guest rizla]

just one problem i can see the bar behind the seats is at a lower level than the sides and back of the boot........hhhmmm hoe do i get the cover to be level

[swan]

hi

try to fit a extra bar / support across the car . it might also be an idea to try and fit the cover down the back of the seats so that the wind doesn't get underneath it when travelling.

 

swan

[Guest ColinR]

Sew corner pockets on each side then use a glassfibre tent pole, slightly over size (length). It should push the toneau cover up in the middle - you will need to add loops in the middle to hold it in place. As swan suggested, run extra material down the back of the seats.

 

Colin

[Guest MrT]

I have a tonou cover and hi back seats, I have inserts fitted so it caps the seat top. When I use the tonou when 2 up I roll the cover back and tuck behind the seat

 

Paul