New Rear End And Light Cluster

[Andi]

Did everyone notice the new rear end of the Zero on the stand in Stafford?

 

Richard said they would do them for 2B`s if there was enough interest. What did you all think?

Unforunately I didnt get a photo.

Wonder if it could be done in stainless too?

 

Andi

[Shaft]

Did everyone notice the new rear end of the Zero on the stand in Stafford?

 

Richard said they would do them for 2B`s if there was enough interest. What did you all think?

Unforunately I didnt get a photo.

Wonder if it could be done in stainless too?

 

Andi

 

 

Andi,

 

yes, i was that impressed with them, so much so, i ordered a pair to go with the zero plus kit i also ordered at the show. I doubt they would do them in St/St though, it was just a modified mould of the standard part for the F/glass. Tooling to press St/St into that shape would cost a fortune unless he was ordering a couple of thousand off???

 

 

Shaft.

[Guest smartfazer]

Anyone got a photo???

[Shaft]

Anyone got a photo???

 

 

Sorry, no pic mate, but roughly speaking, there where 2 off tubular shaped light mounts to take the NAS round lights. They protruded out rearward, horizontally about 1 1/2".

 

Shaft.

[Andi]

Also the rear wheel arches (I think were part of the rear mold too) had stone guards holes in the arches and the stone guards were pushed up from inside the arch so that they were a couple of ml recessed to the arches. Looked surprisingly good.

 

Cmon Rich post a pic.