Front Camber

[spg]

I need to adjust the camber on the front wish bones, But I've made life difficult by welding and gluing the cycle wings on. Before I could just remove the the dummy strut to adjust, But with the cycle wings are in the way so I need a plan b.

 

Don't fancy spliting the ball joint from the strut as It's a real pain to undo and tighten.

 

So I was thinking about removing the top bone from the chassis, Front bolts a doddle to remove just leaving the awkward but possible rear bolt to woory about.

 

Anyone else adjusted the front set up this way, Apart from the rear bolt are there any pitfalls I should watch out for.

 

Cheers

 

Steve

[Grim]

i've done it with a different front setup, jack up the front, undo top bolts, spin wishbone around, bob's your uncle!

[Guest Dan_Beeston]

I can just about adjust mine with the cycle wings still attached, remove the dummy strut/wing assembly from the upright and spin the whole lot around, manhandling it to clear uprights/headlamps/body etc as it moves..........