Coilover Mounts

[mwspit1500]

Hi

Has anybody got some pic’s of the rear coilover top mount (the bit that goes into the roll over bar)

I am wanting to up grade to the coilovers

 

Thanks

mark

[Guest Ant]

Not got a photo, but they're made from two parts. One is a tube, about 6 or 8 inches long which fits into the bottom of the roll-over bar. The bottom of the tube has a U bracket welded to it - almost identical to the bottom bracket for the front coil-overs. The top of the coilover goes inside the U and a bolt goes through to hold it in place.

 

Ant

[Guest bloke]

a pic, hth

[mwspit1500]

Thanks for that Ant and Bloke

Did you have to cut any of your roll over bar off ? pic if poss.

 

Thanks again

 

Mark

[Guest Ant]

I didn't cut anything off. I adjusted the ride-height my moving the nuts on the dampers once I'd got the fuel tank in etc etc. The only problem with adjusting the nuts is that you move the bottoming out points on the coilovers relative to the normal load position. If bottoming out becomes a problem then you might have to trim the tube a bit, but it's accessable later if need be.

 

Ant