Zetec

[1186497]

Good Evening

 

Just looking for some quick advice to help my next weekend go smoothly!

 

Fitting 2l blacktop zetec to a type 9 and trying to collate all the bits in advance.

 

Type 9 gearbox

R1 Carbs

ST170 manifold with rubbers

R1 Fuel pump

1.8 ztec flywheel, was going down the lightened route but cant find a cheap deal

Standard pinto clutch

Do i need a spigot bearing FINIS code 1554973 or will this be the same as what i has on my pinto to type 9 setup??

Release bearing Quinton Hazell part CCT133, do i need one of these ??

New flywheel bolts, are these really needed ??

Starter motor, have the standard pinto one but think it is the large diameter one, in which case presume it wont fit so need Lucas LRS543 ??

A bottle for crank breathing.

Have ecu sorted and alternator/water pump, mounts. Is this everything to get the engine in and potetnially running?

 

Thanks for any help

Simon

[Guest whiz]

Hi you will need the spigot bearing and Release bearing Also the starter motor.

 

Andy

[Guest Hammy360]

Hi you will need the spigot bearing and Release bearing Also the starter motor.

 

Andy

 

I've got a similair set up to you whatever you do dont forget the spigot bearing I had to take mine out again! I used the westfield thrust bearing a starter from a DOHC but I do have the MT75