Lsd Diff With Bolt On Shafts In A Zero

[Guest whiz]

Has anyone fitted a diff with the bolt on shafts to a zero. Mines was originally fitted with push in shafts but I've now fitted bolt on shafts and diff. The shafts seem to be a little too long. I know that GBS have one in there workshop so I'm calling them tmw.

Andy

[Guest tom-zero]

yeah i have fitted one, its the only one i have fitted and i had to use 3 spacer plates each side on the hubs gbs supplied these i think they where 3mm each so 9mm spacer in total i can try and find a pick if its usefull

 

hth Tom

[Pete Mar]

 

Same thing here, you have to put in the spacers supplied by GBS or you will not be able to push the drive shaft in enough to fit the bearing carries. I also used three spacers but even this was a little tight so I would go for four of them.

 

Pete