Pictures Of Zero Bias Pedal Box And Info

[Guest Andy Gaskell]

Hi all,

 

I have bought a kit from GBS to convert my single pedal box to a bias box and looking for some pictures to reference against for when i get the grinder and welder out to start making it up.

 

Also can anyone recommend any bias master cylinders that they have used that are good quality? Weather they have opted for intergral or remote resivours.

 

Im moving up to wilwoods power lights and the front and leaving the xr4i rear discs

 

Cheers Andy.

[brumster]

Had one on the Exmo. My thoughts would be

 

1) Go remote reservoirs, gives you more space/flexibility

2) Either do it right and go AP, or else just get Girling/OE quality master cylinders. But just be aware, the standard Girling bulkhead mount cylinder has been cloned world-wide and there are some really *bleep*ty quality pattern parts out there. If you're paying £10 a pop on ebay for an apparent "girling" master cylinder, steer clear of it. The bores will wear out in no time and they are borderline dangerous.

Edited April 3, 2018 by brumster

[Bob Tucker]

CBS always carry a good range. This M/C has remote and integral reservoirs, and comes in a variety of bore sizes.

https://www.carbuildersolutions.com/uk/brake-and-clutch-master-cylinder-kit-0750

 

Rally design also carry Wilwood parts...well worth a look.

[Guest Andy Gaskell]

Im going to use 0.625 on the front and 0.75 on the rear for my wilwood powerlite setup using xr4i rears

 

Bias i have been advised to setup up for 60/40 and 50/50 in the wet

 

Car is 99% track based

 

I was looking at wilwood master cylinders originally but just looking for recommendations before i buy. I dont want to be left high and dry due to infiror parts

[Bob Tucker]

Ive been using a cylinder from CBS for 12 years with no problems.

Plenty of choice here...

https://www.carbuildersolutions.com/uk/master-cylinders

[Guest Andy Gaskell]

Thanks bob