Bonnet Fitting

[jmspec]

I have just finished refitting the nosecone on my superspec.

Inside the nosecone is very full. The radiator is touching the cross member and the intercooler is touching the radiator.

The trouble is the nosecone is sat up by about 3 mm and so I have a 3mm gap at the front between the bonnet and the side panel and flush at the scuttle end.

Has anyone had this problem and what has been used to fill the gap and still looks good.

I was thinking of a tadpole beading, but not sure. Any suggestions and photos please.

Jez

[fry61]

Look at the wheel arch edge trim in CBS-- should be able to stick on with bonnet shut & there fore end up with no gap between trim & bonnet.

[jmspec]

Thats all I could think of doing with tadpole stuff. Was hoping for some more ideas.

Jez