Taper Reamer

[Guest hull hoody]

Does anyone have a taper reamer to match a maxi bottom ball joint?

Willing to buy or return after use...

Or does anyone know the size of taper I require so that I can purchase one myself.

Thanks in advance

[ozz]

they say on the haynes roadster forum that the 19mm axminster handy reamer is the right tool to open up the sierra uprights to take the maxi ball joint. I've not done it myself but have the reamer and it is a very useful tool and cost 4 pounds. Search for axminster tools.

Ozz

[Dave R]

i have one

same source as above

they are the correct taper, but not that good in quality!

they are however, good enough to complete at least one pair of hubs

 

prob cheaper if you buy your own, than pay the postage to borrow

 

dave

[Guest hull hoody]

Thank you both, for the recomendation site found and one ordered.

Steady as we go then with a bit of cutting oil to assist