2B Plus - Measuring Caster Angle?

[Jez Morton]

I found on mine the front suspension wish bone mounts slightly off set, i needed to screw left ball joint further in to set camber. With Tims setup that reduces the caster on the left side due to the angle of the wishbone tube that holds the ball joint, to correct I had to move one wishbone by changing the spacers on the rose joints. I moved the wishbone on the side which was furthest from what I wanted.

 

Jez

[Guest Phil Slater]

Just had my car set up professionally checked and as the attatched printout shows just a little bit of tweaking on the front camber is all that is required..

 

I'm particularly pleased with rear set up as, during the build, for a jar of coffee and packet of bicuits I'd managed to to get blank spacers computer cut to use as camber wedges. Unfortunately I couldn't get the taper milled on to them so I had to file them by hand. Very laborious as I recall and not all that accurate but obviously better than I thought.

Edited July 26, 2014 by Phil Slater