XJ220

Have you considered a hydraulic conversion, I converted mine with a master cylinder and slave cylinder kit for a Land Rover Disco and some imaginative planning and your away, clutch much lighter and clutch bite point can be set to preference.

Thanks for the info, have contacted them and they are able to help.

That's a big relief I was starting to think I would have to manipulate all sorts of odd bod things to fit.

Good Day All,

A few weeks ago I had a coming together with a motorcycle which rode straight across my path at a set of lights, I am now looking for a company who can fix my car as the insurance prefers it to be fixed by a repairer, the damage is just the bonnet, nose and the panels below the nose.

If anyone can let me know of such a company it would be much appreciated, failing that is there anyone around who can supply an S7 bonnet and nose.

Cheers

Shane.

Thanks for your reply, did think of that but was looking to try and keep the electrical architecture as authentic as possible but if needs must I suppose.

Hi,

Could anyone tell me where I can get hold of a six pin connector for a Pinto ignition amplifier, got it wired with individual terminals at present and not happy with it's robustness for reliability.

Many Thanks

Shane

Hi there,

Does anyone know where I can get hold of the 6 pin connector for a Sierra/Cortina Pinto ignition amplifier, I have just bought a rolling complete body tha just needed engine and transmission and the ignition wiring, got everything except the amp connector.

I have wired it up with individual insulated pins but looks ugly and not robust enough for reliability for my liking.

Thanks

Shane.

Hi All,

On my Mk3 there are four holes in the centre of the floor pan just in front of the seats on both near and off sides, does any one know the purpose for these holes as they look like they were done at the point of manufacture of the kit.

Thanks

Shane

Thanks Paul,

The dimension of the panels are the measurements at their widest points,

Left picture - 33cm along the edge with the bend x 24cm

Middle picture - 42cm x 21cm

Right picture - 27cm x 26cm

I have tried to offer them up all over the car and nowhere do they look right.

Shane.

Hello,

I have recently purchased a partially constructed stainless steel monocoque RH, the chassis is complete and rolling but I have a number of panels which came with the car and I have no idea where they are intended to be fitted, see below photos of the said panels and if anyone can identify what there purpose is and where there need to fitted it would be much appreciated.

Many Thanks.

Shane.