Core Plugs

[Grim]

Has anyone ever replaced any of the core plugs on their pinto? How easy of a job is it to do?

 

I've got a small water leak out of one of mine, and i'm wondering if it is something i should attempt, or just leave it untill it loses more coolant?

 

Haynes says "Knock out the old plugs with a hammer and chisel or punch. Clean the plug seats, smear the new plugs with sealant and tap them squarely into position."

What does that translate to?

 

Andy

[Longboarder]

Very easy. Knock a hard point through at one edge. It may spin or perforate and will then come out easily. Otherwise as you describe. Get a full set and do them all. If one's going they're all dodgy.

 

Nigel

[Guest yosamite sam]

i did mine last year - big screwdriver or similar - whack it through the plug - WITHOUT GOING TOO FAR!

 

tap it around to loosen it then flip it out - clean the hole in the block with fine wet n dry carefully not getting any bits in't hole in't engine the plug will be tight to refit - use a big socket to drive home - it may be tight - there is some sealer you can use - cant remember the name

[Grim]

Thanks

 

If someone know the kind of sealant it is, that would be helpful

[Guest art b]

a smear of loctite is what i use!