Super Spec Top Ball Joint Rubber

[Guest bugsy]

Hi All,

 

Does anybody know what the upper ball joint seal is off on the super spec and where i can get them from?

I have just replaced the track rod ends and now need to get the upper ball joints done as is an MOT fail.

 

 

Thanks

Bugsy

[alanrichey]

Ford Transit I think although not 100% sure.

[Guest Ian & Carole]

Transit drag link.

 

But just change the boot http://www.balljointboots.co.uk/

 

Much cheaper if joint is OK.

[Guest bugsy]

Thanks guys, I have managed to get the old ones off and ordered new ones, for info the hole sizes are 15mm and 30mm approx.

[agent_zed]

when you put them on and have to get the spring clip back on i found it best to put a bit of card at the sharp end so you don't pierce the rubber. Get one end in place and then work around (think i used a screwdriver) until it all sits down correctly.

 

hth

[Guest bugsy]

Thanks for the advice agent-zed, the spring does look like it had a part to play in the old ones breaking up, they were totally shot, especially round the bottom end.

hopefully this should be the last thing before the MOT!

Cheers,

Bugsy

[Guest Mark Anyon]

Hurry up Paul get it finished pal

 

run out needed

 

Mark