peter

Hi Steve, Thanks for the advice. I was thinking of a u section made of flat bar going under prop shaft and welding to floort and tubes. Thanks, Peter

Hi, Need a little help? I am building a Robin Hood 2b and am wandering how you fix a four point seat harness. I seem to be ok with rear and side, but do not know how to fix mount nearest center, ie around drive shaft column. I have a couple of 1/8th bars spanning the floor for seat fixings. Thanks, Peter.

Hi, I am trying to wire up my Robin Hood 2B. I have a new wire Harness, purchased from Great British Sport's Car in 2010. Unfortunately I do not have an installation diagram. I seem to remember seeing one in the form of an A4 sheet with a plan of car and colure lines for wires. Unfortunately I cannot trace this. Has anybody out there got a copy they can e-mail me, or can indicate where I may get one. I am about to start, with a multimetre to start tracing through my harness and trying to work out what goes to what, but I fear I will possibly have to dump harness and start from fresh. Help please! Thanks, Peter.

Hi, I am currently assembling a RH2B. As part of the build I am installing a 1999/2000 Honda S2000 engine. I have the engine installed, but I also have a million wires I am having trouble untangling. I have had a first filter to get rid of wires for electric windows etc, so think I have a minimum set. But need help to get them together. Is there anybody out there who has done a similar project and can advise as to the best way to proceed? Thanks, Peter