-
Posts
17 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Store
Community Map
Posts posted by waz2710
-
-
Hello there I am struggling to time my 2.0 pinto,I need to know how many degrees I need to set the crank to also if I need to advance the timing and do I start with the big mark in the crank tdc,if someone could help much appreciated.
-
Hi
Needs some help please
I have a rear fog light but I can't locate the rear fog light wiring in the dash.
I am in the middle of a robinhood 2b build.
any help would be appreciated thanks
-
-
-
Hi
Need this info please for my build.
The correct measurements for the rears brake and indicators cluster and the fog and the reverse light.
Need to make sure this is correct fitting for the iva.
Thanks
-
Just as I thought many thanks for your help.
-
Hi
whats the best route to get all the wires to the back of the car.
for the rear lights,fogs,reverse light and the number plate light.
all help very much appreciated.
-
56 minutes ago, richyb66 said:
Do your relays click when you operate the relevant function? If they do, then the issue is probably the relay output wiring but if they don't, it's the switched feed to the relay.
What harness are you using, the original Ford one?
Original ford Sierra 1.6l it's on 1992.
I will double check the relays.
Thanks for your reply.
-
,Thanks.
I am not using a windscreen or wipers or washer pump. As my robinhood 2bhas aero screen.
Any diagrams would be helpful.
At the moment my right hand stalk has an earth on 32 pin and there is a link wire between 56 on right hand stalk to the left hand stalk and also an earth on 15 pin of the left stalk.
I have 3 relays
Blue colour dim/dip relay has these pins 86,86,87,87a, and 30.
White colour High beam relay with these pins
85,86,87-1,87-2, and 30.
Small blue colour Dim and dip relay with these pins.
85,86,87a and 30.
Sorry for the long message am not very good with electrics all help is very much appreciated.
-
Any help with ford sierra later 90bg stalks set up much appreciated.
-
Ok thanks.
I will do some more research
-
-
Hi do I need to connect these even though I do not need them.
Front heater matrix and pump.
Front wipers and motors.
Rear wipers and motors.
Thanks
-
Cool thanks bud I will try this method tomorrow.
-
Hi
help urgently need please.
in the middle of building my robinhood 2b.
i am wiring my late ford sierra stalks up but am having some issues.
Main beam works with ignition on but not with ignition on.
Dipped beam does not work with ignition on or off.
i have tried this on my donor vehicles front lights.
thanks
-
Hi
I am in the middle of building a robinhood 2b donor vehicle is a ford sierra 92 plate.
couple of issues i am having and need help with.
how do i wire up the headlights,my sierra loom has 6 wires each for the headlights but my dome lights have 4 wires each light.
thanks
Front brake flexible brake pipes
in Mechanics
Posted
Hi
I am in the process of building a robinhood 2b with a donor vehicle being a Ford Sierra.
Issue I am having is I ordered the brake pipes using my Ford Sierra reg from euro car parts bit they are way too small.
Does anyone know where I can get bigger pipes.
Thanks